[Please help] Geotel G1
[Please help] Geotel G1
(14-10-2018, 05:21 AM)intercepter After flashing stock firmware with sp flash tool my telephone is dead.When try to flash again with SP flash tool always get error enable DRAM failed code (4032) .Is it possible to unbrick this phone?Thanks.
(14-10-2018, 05:21 AM)intercepter After flashing stock firmware with sp flash tool my telephone is dead.When try to flash again with SP flash tool always get error enable DRAM failed code (4032) .Is it possible to unbrick this phone?Thanks.
(15-10-2018, 11:39 AM)EMMANUS was this the firmware you tried? https://naijarom.com/geotel-g1
(15-10-2018, 04:10 PM)intercepter Yes.I tried with this stock rom because my phone is freezing many time,sometime freezing on the boot.My first mistake,I don't make backup nvram.I flash phone with SP Flash tool and receive mesage at end 'ok'.After that phone is dead.Maybe I chose format+download,don't remember.
When try to upload firmware again a see mesage 'Download DA 100% ok' mediatek usb driver,and after 10 sec. receive error 'S_FT_ENABLE_DRAM_FAIL (4032)'.
Problem is I not see mediatek da usb vcom driver on SP tool or device manager.I think is not about instal driver because I try with many driver manually or auto install.I have another Geotel G1 who works perfect and I make backup with this phone successfully,also see both driver in device manager.
In the first attempts both driver is running but with same error.Sometimes first show da usb vcom driver and SP tool not running.
Now I open the phone,find KCOLO pin and short connect with GND.Unfortunately only see mediatek usb driver,but this time without volume- button when connecting phone.Maybe I need different procedure?
On board I see this point:
RX
TX
POWER(from power button)
KCOLO
OTGID
FCHR_ENB
VBAT
and two pin KROW0 5 or KROWU 5,not sure.
Sorry for my english.Thanks.
(16-10-2018, 10:22 AM)juvette Try updating the mediatek usb driver using the guide @ https://www.hovatek.com/forum/thread-16839.htmlIs it possible that the problem is in the drivers?Because I can make backup from another working phone.
(16-10-2018, 08:10 PM)intercepter(16-10-2018, 10:22 AM)juvette Try updating the mediatek usb driver using the guide @ https://www.hovatek.com/forum/thread-16839.htmlIs it possible that the problem is in the drivers?Because I can make backup from another working phone.
(16-10-2018, 08:10 PM)intercepter Is it possible that the problem is in the drivers?Because I can make backup from another working phone.