Infinity CM2 v2.10 - question
Infinity CM2 v2.10 - question
(17-01-2021, 03:24 PM)zhelan This update adds the support of additional devices including devices with unisoc T610. Is it possible to root those devices now using cm2?
(18-01-2021, 04:32 PM)zhelan But couldn't it be used to root it. I mean :
1. Extract firmware
2. patch with magisk
3. Write firmware
Or it is not possible?
(21-01-2021, 02:52 PM)hovatek(18-01-2021, 04:32 PM)zhelan But couldn't it be used to root it. I mean :
1. Extract firmware
2. patch with magisk
3. Write firmware
Or it is not possible?
Tested it on the Hisense A5 Pro CC, doesn't work.
Can't speak for other Unisoc Tiger T610 devices
(02-02-2021, 10:24 AM)Timo Helfer Which drivers did you use for the Hisense A5 Pro CC? I tried several but I always get error like Fail to init handshake protocol, or other errors that I should connect the device again.
Did you press both voulme buttons when plugging in`?
Infinity-Box Chinese Miracle II : SPD/USC Module [SP2] v2.10
Load IDBase v8331 Ok!
Operation : Identify [ v2.10 ]
BootMode : FLASH
1. Power off device, wait 10-15 seconds
2. Press and hold BooKey ( 1 : BOTH VOL , 2 : VOL+ , 3 : VOL- )
3. Insert cable in device!
Wait for device ...
Device Connected!
BootVersion : SPRD3
Boot : INF : 0_UT61x_BASE : UT61x_eMMC_4GB_0S
Sending Init Boot ...
Boot sent!
Kick FDL ...
>>> ERROR : FDL NOT started!
>>> Error : Fail to boot FDL!
>>> Unsupported device with selected fdl or settings! Change settings!
Reconnect Power/Cable!