TECNO D3 HARD BRICK ISSUE
TECNO D3 HARD BRICK ISSUE
(28-10-2014, 12:34 AM)ugo.elvis Am having issue with my tecno d3, just wake up one morning to see my D3 phone totally dead, above all the phone wasn't even rooted. Then it was vibrating when switched on but PC cant recognize via usb cable. After i tried flashing in the scatter file as instructed from your site with Sp flash tool, it showed a 100% red progress bar and stopped with an error message. Then I formatted and the phone seized to vibrate ever since. Each time I want to flash in either of the preloader or the scatter file, It keep giving an error message as thus; 1. "8038 preloader fail to load. PMT is ready and layout has been changed,Please use firmware upgrade to download to avoid important data loss." 2. BROM_ ERROR;S_DL_BL_INVALID_GFH_FILE_INFO(5066) Fail to load ROM file; preloader. Please kindly direct me what to do/files to download to restore back my phone to normal. Expecting the needed help from you
hovatekugo.elvis Am having issue with my tecno d3, just wake up one morning to see my D3 phone totally dead, above all the phone wasn't even rooted. Then it was vibrating when switched on but PC cant recognize via usb cable. After i tried flashing in the scatter file as instructed from your site with Sp flash tool, it showed a 100% red progress bar and stopped with an error message. Then I formatted and the phone seized to vibrate ever since. Each time I want to flash in either of the preloader or the scatter file, It keep giving an error message as thus; 1. "8038 preloader fail to load. PMT is ready and layout has been changed,Please use firmware upgrade to download to avoid important data loss." 2. BROM_ ERROR;S_DL_BL_INVALID_GFH_FILE_INFO(5066) Fail to load ROM file; preloader. Please kindly direct me what to do/files to download to restore back my phone to normal. Expecting the needed help from you
1. do you have the MTK backup for D3?
2. what version of sp flash tool did you use?
(29-10-2014, 12:18 AM)ugo.elvis Also installing the USB VCOM DRIVER always end up with error code 10 "The software for this device is now installed, but may not work correctly. This device cannot start (code 10)" . Tried it more than thrice with the message
(31-10-2014, 10:09 PM)ugo.elvis Thanks for the mtk d3 back up. have downloaded the sp flash tool version 5 but the platform is not as the former. How do i go about flashing it in to my phone. Do i follow the former tutorial?
ugo.elvis Have gone through the process again, this time with the SP flash tool version 5 with the backup you sent me but to no effect. The scatter file loaded smoothly on the tool without any error message as in the previous case, but upon connecting the Usb cable; the splash tool will become unresponsive to either of the Format or the Download button (NOT RESPONDING) . I tried out the scatter file with the previous versions of the SP flash tools. Again they load smoothly but they format successfully, but give either of these message upon pressing Download 1. "BROM ERROR:??(6)" 2. "SP FLASH TOOL ERROR (8038) Please use firmware Upgrade instead of Download to avoid important data lost". But the firmware/upgrade button could not work either. Please note the TOOL (old) is observing/recognizing the usb port "Mediatek usb port 23". Please whats my next action as your the only one i believe will get me out of this mess. Thanks in anticipation