Steps to flash a Mediatek (MTK) phone using GSM Aladdin Box
Follow the steps below to use GSM Aladdin to flash Mediatek devices
Extract the content of the GSM Aladdin zip and double-click GSM Aladdin 1.34.exe
Click the Mediatek tab
Tick WriteFlash
Select your chipset type under Model Option or leave as Auto Detect if not sure
Set to USB
Click the Browse icon at the bottom right corner
Navigate to the location of the backup, select the Scatter file then click Open
Click Connect (at the top)
Click Start
Connect the phone (via USB) while switched off and with a charged battery inside
The phone should get detected
A box should popup, tick the partitions you wish to flash to the phone
You should now see >>> Writing Flash Wait...
Flashing should begin, do not interrupt
Once flashing is done, you should see Write Done 100% . Disconnect the phone then boot
Important Notice
GSM Alladin ideally requires a hardware box. Running the setup without one won't work
If you are using a loader version (no hardware box required) then your antivirus might flag it. You are entirely responsible for your decision to heed or ignore
You should only flash firmware for your phone model. Doing otherwise could brick it
Avoid interrupting the flashing process because that could cause the device to go dead
For best compatibility, flash back GSM Aladdin box backups using the tool
For Secure Boot devices, you'll need to load the DA file
This post was last modified: 01-11-2019, 04:04 PM by hovatek.