This device has the Marvell Chipset with few unlock support generally. There many variance of M022, M023 and M028T, which includes L02B, L02C, L02D, and many more WITH LCD AND LED, Dont just try, identify the difference.
Warning; Flashing an incompactible firmware may results to signal damage, searching for network issues and more likely NOT UNLOCKED permanently.
L02C has been successfully Unlocked, will upload soon
This project and it other variance unlock shall remain FREE
WARNING
If you cant disassemble and check variance on PCB DONT TRY unless you are very sure about its variance L02B LCD
This guide works on L02B LCD ONLY
NEVER TRY THIS ON L02C AND L02D
ALL REQUIRED FILES POSTED BELOW
Installing Required Driver for unlocking Boost even mifi
- Download and extract unlock files
- Install WTPTP driver based on x86 and x64 bit
- Launch device manager
- Install Generic Mifi Drivers manually, do this by clicking "add new legacy hardware" > Select " Install the hardware that I manually select from a list (Advance) " then click Next.
- Click "Have Disk" then navigate to and select the "LTE MIFI Generic" driver
- Wait till installation is complete and you should see "Marvel AT Interface(COM **)" under device manager
How to unlock L02B variant
- Disassemble and check pcb of device as shown L02B
- Read instructions in picture
- pay attention: the aim is to disconnect the mifi at some % erase flash to allow the device to accept different incompactible loaders somehow....
disconnect mifi at 6-10% erase flash if 3% skipped you so fast
WINDOWS 10 USERS ( ATTENTION)
Wait, pay attention to erase flash and disconnect at ERASE FLASH COMPLETE
DISCONNECT WHEN ERASE FLASH IS COMPLETED
Connect mifi without battery to pc to start flashing
- Flashing the LED firmware, follow same instructions in the picture
- Open software, Open and select Nehza file to load flash files
- Tick other non ticked files, select in options erase all flashed
- Proceed to start and connect device without battery again to flash
- Do not interrupt the flashing, till finish
Disconnect mifi
- Flashing the Last firmware
- Same as immediate flashing done, Open and select Nehza file to load flash files.
- Tick other files if not already ticked
- In options Unmark Erase all flash, check and disable erase all flash if already enable in Options (VERY IMPORTANT)
- Disconnect device and insert battery now
- Insert non-default sim card, device as for PH-NET PIN,
You will see PH-NET_PIN each time you reset your mifi Unlock code is 123456, DONT FORGET
- Login to dashboard and type login and password "smartbro" as username and password NOT admin
- Skip welcome page, Click on Internet TAB,
- Select MEP settings, type Unlock Code as 123456
Unlock Code accepted, please wait, you should see searching for signals on MIFI, it displays the 3g signal of the Sim
NB: It does not support some 4g/LTE after this method for Unlock
It works great on all other 3g networks, few 4g networks are supported. At least better than still locked without help
Tested on GloGH, Vodafone and Tigo, Busy 4g all working perfect
DOWNLOAD LINK
[L02C has been successfully Unlocked, will upload soon]
https://goo.gl/7xivJE
No password
[size=large]
All done by droidmobitech
Thanks to Chancellor for donating a device for Trial, First unlock test and tutorial
<TEAM DMT>
This post was last modified: 08-11-2018, 09:49 PM by
X3non.