Tecno La6 Pouvoir 1 error after frp reset
Tecno La6 Pouvoir 1 error after frp reset
(31-07-2018, 10:21 AM)awesonjude I have a Tecno La6 Pouvoir 1, it was reset and the frp was removed using miracle box but resulted in supported API screen due to the secure boot.
I later downloaded the custom DA file and the full firmware. After flash, it hang at the Pouvoir logo. If i try to enter recovery, it goes back to the supported API screen and wont get out until i do a full flash again.
(02-08-2018, 07:26 PM)awesonjude Not entering the normal factory mode nor recovery mode.
I tried entering factory mode, it'll show the factory mode written in yellow then pops up test mode
(19-12-2018, 02:44 PM)Bethelnova I have the same problem here too... Holding + power key didn't work