[Tutorial] How to fix an Infinix Note 2 X600 totally dead after flashing wrong firmware
[Tutorial] How to fix an Infinix Note 2 X600 totally dead after flashing wrong firmware
(21-06-2016, 12:52 PM)emperor1 hello everybody in this forum.
my name is emperor and i need some help to fix my TECNO M3. it automatically turn on WI-FI and data by itself. what should i do?
(26-06-2016, 08:47 AM)ife007ade pls hovatec i did not understand d jumper tin pls help me.. .. help me to mark where and where i nid to conect together
(27-06-2016, 12:36 PM)deetee Please how long will i have to keep the jumper between the ground and the force boot pinout and do i have to connect back the battery before flashing or flashing without the battery been connected.
(17-02-2016, 08:55 PM)mhmyasser !!! PLEASE READ THIS ENTIRE POST BEFORE PROCEEDING !!!
this tutorial applies to all infinx note 2 X600 and it is not require a specified firmware do it when your phone totally dead (no boot, not detected by pc)
Caution :
Do it at your own risk, i'm not responsible for any bricks you may obtain. Please follow the thread rules and steps and everything will be gravy. Remember, select the right firmware for your phone
You must have the following to revive your phone:
- A hardware knowledge
- The right firmware for your phone " notice for 532 or 533 board "
X 600 H 532 A1 L 20151214 here: http://adf.ly/1X4Uuu
X 600 H 533 A1 L here: http://adf.ly/1X4Vhu
X 600 H 533 B1 L 20160120 here: http://adf.ly/1X4VLT
if you don't know your board number it will be written on the board as you will see in the pictures
- infinix drivers and xflash tools here : http://adf.ly/1X55aL
- and of course a pc
how to do it:
- install the drivers
- identify your board number for the right firmware
- after confirming that you have the right firmware
start xflash tool and load the scatter file and press start
- only connect the socket in the picture after that connect the usb cable " the pc must not detect the phone at this point "
- make a jumper between the ground and the force boot pinout
" just make the jumper for one touch don't keep them connected"
once you make that you must here that your pc recognize your phone and the xflash tool will make the rest
Contributors:
mhmyasser
thanks to "satin" for the pictures
thanks to "hovatek"