pls Help
pls Help
(05-04-2016, 08:10 AM)yasermuny187 As I said in my first post whenever I use Volume up + power, it goes to this is what is shown and up side down :
<< Select boot mode:
[VOLUME_UP to select. VOLUME_DOWN is OK.]
[recovery mode]
[fastboot mode]
[normal mode] >>
I can use the volume up to choose, but whenever I click volume down, or others nothing happens.
Now what can I do to correct font ?
(05-04-2016, 11:42 PM)hovatek(05-04-2016, 08:10 AM)yasermuny187 As I said in my first post whenever I use Volume up + power, it goes to this is what is shown and up side down :
<< Select boot mode:
[VOLUME_UP to select. VOLUME_DOWN is OK.]
[recovery mode]
[fastboot mode]
[normal mode] >>
I can use the volume up to choose, but whenever I click volume down, or others nothing happens.
Now what can I do to correct font ?
Seems you don't have the stock recovery.img
You have two options
1. Get the firmware
2. Use ADB
Let's try adb. Setup adb using https://www.hovatek.com/forum/thread-588.html
(10-04-2016, 03:39 AM)yasermuny187 I re install ADB as requested and work properly with another phone but when I connect default phone I got in device manager this error unknown device << Windows has stopped this device because it has reported problems. (Code 43)>>
(10-04-2016, 08:47 PM)hovatek(10-04-2016, 03:39 AM)yasermuny187 I re install ADB as requested and work properly with another phone but when I connect default phone I got in device manager this error unknown device << Windows has stopped this device because it has reported problems. (Code 43)>>
Right-click what it gets detected as then uninstall and scan for hardware changes
(11-04-2016, 03:50 AM)yasermuny187 I do that, windows 7 gives message green sign beside unknown device but need to restart windows , after restarts no change! by the way did your post : https://www.hovatek.com/forum/thread-440.html the same.
Thanks
(11-04-2016, 04:24 AM)yasermuny187 Excuse me for your information as I have trouble in USB charging port for the phone,I assemble connection cable by cutting the phone end of original phone cable and solder 4 lines to the main board of the phone ,I found pad :
USB-DM and I considered it -DATA
USB-DF and I considered it +DATA
beside VCC and GND
is it right?
(12-04-2016, 05:45 PM)yasermuny187 OK as I can't reach the buyer cause my phone is copy and can't reach PC because of non ability to install right driver or else error to use ADB .....and as I can reach recovery e3 and rest factory and wipe data partition So what about to correct font or do anything from UPDATE FROM EXTERNAL SD choice please let know your advice