Hi, Guest! Login / Register
Giveaway: Free Hovatek T-shirts, Hoodies & Cufflinks.. I WANT ONE! (Nov 25, 2017)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

[Please help] Infinix 509

#1

please urgent response needed!

i try to flash infinix 509 with infinix flashtool and the flashing interrupt by unfortunate usb disconnect after at list 30% , after that I'm very tied to flash because its stocking at infinix logo if it switch on and only shows  battery bar charging when connect to flashtool, but i can boot to the stock recovery and bootloader.


Reply
#2
(This post was last modified: 09-01-2016, 12:10 PM by Christianihechi. )
(09-01-2016, 11:10 AM)Aminu Garba Ahmad Wrote: please urgent response needed!

i try to flash infinix 509 with infinix flashtool and the flashing interrupt by unfortunate usb disconnect after at list 30% , after that I'm very tied to flash because its stocking at infinix logo if it switch on and only shows  battery bar charging when connect to flashtool, but i can boot to the stock recovery and bootloader.


Since the flashing process was interrupted, there is no need trying to boot into recovery because the file system has been altered incompletely and wont boot up. You should try forcing it to power off completely and then re-flash if not it would just charge when you connect it to your PC.
Reply
#3
Reflash until 100%

Sent from my INFINIX-X551 using Hovatek mobile
Reply
#4
(09-01-2016, 12:07 PM)Christianihechi Wrote:
(09-01-2016, 11:10 AM)Aminu Garba Ahmad Wrote: please urgent response needed!

i try to flash infinix 509 with infinix flashtool and the flashing interrupt by unfortunate usb disconnect after at list 30% , after that I'm very tied to flash because its stocking at infinix logo if it switch on and only shows  battery bar charging when connect to flashtool, but i can boot to the stock recovery and bootloader.


Since the flashing process was interrupted, there is no need trying to boot into recovery because the file system has been altered incompletely and wont boot up. You should try forcing it to power off completely and then re-flash if not it would just charge when you connect it to your PC.

It just charge when i connect for re-flashing
Reply
#5
(09-01-2016, 12:37 PM)peter osoro Wrote: Reflash until 100%

Sent from my INFINIX-X551 using Hovatek mobile

it only charging any time i connect.
Reply
#6
(09-01-2016, 12:49 PM)Aminu Garba Ahmad Wrote:
(09-01-2016, 12:07 PM)Christianihechi Wrote:
(09-01-2016, 11:10 AM)Aminu Garba Ahmad Wrote: please urgent response needed!

i try to flash infinix 509 with infinix flashtool and the flashing interrupt by unfortunate usb disconnect after at list 30% , after that I'm very tied to flash because its stocking at infinix logo if it switch on and only shows  battery bar charging when connect to flashtool, but i can boot to the stock recovery and bootloader.


Since the flashing process was interrupted, there is no need trying to boot into recovery because the file system has been altered incompletely and wont boot up. You should try forcing it to power off completely and then re-flash if not it would just charge when you connect it to your PC.

It just charge when i connect for re-flashing

Try forcing the phone to power down[holding power button for a while] before flashing again.
Reply
#7
So it doesn't enter preloader mode first before showing charging battery?
Confirm under device manager.
And It's healthier to use infinix flash tool

Sent from my INFINIX-X551 using Hovatek mobile
Reply
#8
hi, is your infinix 16 gig or 32 gig?
Reply
#9
(09-01-2016, 11:10 AM)Aminu Garba Ahmad Wrote: please urgent response needed!

i try to flash infinix 509 with infinix flashtool and the flashing interrupt by unfortunate usb disconnect after at list 30% , after that I'm very tied to flash because its stocking at infinix logo if it switch on and only shows  battery bar charging when connect to flashtool, but i can boot to the stock recovery and bootloader.

Hold volume down before connecting to pc and a few seconds after you have connected for flashing
Reply
#10
(09-01-2016, 12:52 PM)Aminu Garba Ahmad Wrote: it only charging any time i connect.

Try taking out and reinserting the battery.
Also, consider reinstalling VCOM drivers.
See the fix for showing charging sign instead of flashing @ https://forum.hovatek.com/thread-439.html
Need further assistance? Speak with a Hovatek Representative:
Working Hours: Mondays - Saturdays ; 09:00 - 18:00 (GMT +1:00)
Reply










Users browsing this thread:
1 Guest(s)