[Tutorial] How to setup Eyeprint recognition on a Tecno Phantom 6 (A6)

[hovatek]

The Tecno Phantom 6 comes with an Eye Scanner. To setup the Eyeprint recognition:

• Navigate to Settings and tap Eyeprint identification
  

• Tap the + icon
  

• Set a 4 digit PIN which will act as a fallback incase Eyeprint recognition fails or is unavailable (you'll be required to input it twice for verification)
  

• Under 'Eyeprint is appplicable for' , toggle Unlock to On (Off is Grey,On is Gold)
  

• You should get a notification asking to allow EV service permissions, tap OK
  

• Under EV service, toggle Camera to On (Off is Grey, On is Teal Green)
  

• EV service should now have permissions to use the front camera
  

• Go back to the Eyeprint recognition setup screen and tap the +icon. Enter the 4 digit PIN to proceed
  

• Go back to 'Eyeprint is applicable for' and toggle Unlock to On if it isn't set to On (Off is Grey,On is Gold)
  

• Place your face within 15cm from the screen and focus on the progress bar (loading from 0-100%) till you get a confirmation that the registration of our eyeball information is successful
  

• Test your setup by pressing the power button once (to sleep) then another time (to wake) then swipe from the bottom of the screen to the top
  

• Place your face within 15cm to the screen (till you can see both of your eyes) and the Eyeprint scanner should begin scanning
  

• If verification is successful, you should get a "Verified" message and get redirected to the Home screen
  

• If your eyes are too far away, you should get a "Too far" message
  

*Note: To skip the Eye Scanner and use your 4 digit PIN instead, tap Enter password at the bottom of the screen