To successfully unlock the Bootloader of the Hisense U989 Pro:
* Backup your important stuff as unlocking the Bootloader wipes your data
* Enable USB Debugging on the Hisense U989 Pro (see https://www.hovatek.com/forum/thread-10109.html)
* Enable OEM Unlocking under Settings > Developer options
* Setup ADB and Fastboot on the PC (see https://www.hovatek.com/forum/thread-588.html)
* Connect the phone to the PC via USB cord (while On)
* Launch ADB
* In ADB, run the following command (press Enter after the command)
Code:
adb devices
* ADB should detect the device. If ADB detects other devices but not the Hisense U989 Pro then it must be an ADB clash, see https://www.hovatek.com/forum/thread-10111.html
* Once the device gets detected, boot it into Fastboot by running the following command (press Enter after the command)
Code:
adb reboot bootloader
* The phone should now enter Fastboot (black screen with only fastboot written at the top or bottom)
* In Fastboot, run the following command (press Enter after the command)
Code:
fastboot oem unlock
* You should get a prompt on the device asking you to confirm Bootloader unlock, press the volume down button (It says volume up for Yes but select Volume down instead)
* You should now get a success message
* Reboot the device by running the command below (press Enter after the command)
Code:
fastboot reboot
This post was last modified: 23-11-2016, 02:44 PM by hovatek.