[Tutorial] How to use Miracle Box to backup Spreadtrum (SPD) firmware

[lexar21]

after executing readinfo in my mtk device, the device is not opening, though it reads my device driver, but it cannot flash any firmware via spft nor the miracle. why is it happening? (sorry for my english)

disconnect/reconnect the phone's battery and you're good to go.

sir its good now, its charging now and it open, maybe because it just have to drain the battery so that like the battery is being remove then put it again by charging?

[X3non]

disconnect/reconnect the phone's battery and you're good to go.

sir its good now, its charging now and it open, maybe because it just have to drain the battery so that like the battery is being remove then put it again by charging?

ok, that's good you were able to power on the phone
BTW you know you are on the wrong guide? MTK backup guide is @ https://forum.hovatek.com/thread-13347.html

[lexar21]

disconnect/reconnect the phone's battery and you're good to go.

sir its good now, its charging now and it open, maybe because it just have to drain the battery so that like the battery is being remove then put it again by charging?

ok, that's good you were able to power on the phone
BTW you know you are on the wrong guide? MTK backup guide is @ https://forum.hovatek.com/thread-13347.html

Ok sir, just last concerned. why it cannot open and wait till it drains the battery before it can open?

[X3non]

Ok sir, just last concerned. why it cannot open and wait till it drains the battery before it can open?

it is explained @ https://forum.hovatek.com/thread-808.html
if you still have further questions then create a new thread so we'll focus on it
see https://forum.hovatek.com/thread-514.html for how to create a thread