[Please help] G'five L3 bricked

[JW70]

error.jpg Size: 297.94 KB  Downloads: 3

format.jpg Size: 45.84 KB  Downloads: 4

format.jpg Size: 45.84 KB  Downloads: 4

format.jpg Size: 45.84 KB  Downloads: 4

IMG_8053 - small.jpg Size: 555.87 KB  Downloads: 2

Hi all,

I recently seem to have bricked my phone G'five L3

Because of the amount spyware/malware virus in phone,
I decided to flash it. The comes out of the box with several
infected programs. There are a few stockroms available and
questions at G'five didn't give me any answers so I gave it a
tie solving the problems myself.

Flashing was no problem, I choose the 2 stockroms available
and they both worked, however they were also both infected.
I used format all and download option in SP Flash Tool v5.1708



As there were still infections on my phone I decided to go to the
format tab in Flash tools and choose "auto format flash" "format whole flash".
Unfortunately the bootloader was gone now.

if I connect the phone, the phone pops up in hardware devices and
when trying to flash new preloader, flash tools shows me "MTK USB port (COM10)"
I flashed successfully at first without battery present. but now also tried it with battery and combi on/off
button withvolume up down both buttons pressed or all of them during connecting and flashing.

and error after 56 seconds "Error: S_FT_ENABLE_DRAM_FAIL (4032)" or
"Error: S_FT_ENABLE_DRAM_FAIL (0xfc0)" and "please check your load matches to
your target witch is to be downloaded".

On Youtube I could only find a solution connecting the kcolo measuring point with ground.
but the measuringpoints are not marked. after that I should be able to reflash the preloader.

Any of you guys have a solution or something I can try?
Many thanks in advance !!!

[hovatek]

Hi all,

I recently seem to have bricked my phone G'five L3

Because of the amount spyware/malware virus in phone,
I decided to flash it. The comes out of the box with several
infected programs. There are a few stockroms available and
questions at G'five didn't give me any answers so I gave it a
tie solving the problems myself.

Flashing was no problem, I choose the 2 stockroms available
and they both worked, however they were also both infected.
I used format all and download option in SP Flash Tool v5.1708



As there were still infections on my phone I decided to go to the
format tab in Flash tools and choose "auto format flash" "format whole flash".
Unfortunately the bootloader was gone now.

if I connect the phone, the phone pops up in hardware devices and
when trying to flash new preloader, flash tools shows me "MTK USB port (COM10)"
I flashed successfully at first without battery present. but now also tried it with battery and combi on/off
button withvolume up down both buttons pressed or all of them during connecting and flashing.

and error after 56 seconds "Error: S_FT_ENABLE_DRAM_FAIL (4032)" or
"Error: S_FT_ENABLE_DRAM_FAIL (0xfc0)" and "please check your load matches to
your target witch is to be downloaded".

On Youtube I could only find a solution connecting the kcolo measuring point with ground.
but the measuringpoints are not marked. after that I should be able to reflash the preloader.

Any of you guys have a solution or something I can try?
Many thanks in advance !!!

This is a mismatch error (refer to https://forum.hovatek.com/thread-439.html ). Since you'd previously successfully flashed these firmware, that rules out an incompatible firmware. This leaves 3 options
1. Find a firmware (for this device) of a higher build and flash
2. Uninstall all MTK drivers and reinstall
3. The emmc chip might be faulty