[Tutorial] How to use Infinity CM2 QLM to flash Qualcomm firmware
[Tutorial] How to use Infinity CM2 QLM to flash Qualcomm firmware
Follow the steps below to use Infinity CM2 to flash Qualcomm firmware
See the video tutorial below or at https://youtu.be/d9-l9fTZ4aMQuote:In this video tutorial, I'll be explaining how to flash a Qualcomm Android phone using Infinity Chinese Miracle 2 QLM module. You're going to of course need the module (which I'm going to be installing). You're going to need the firmware (it looks something like this). First off, you'll want to install the CM2 QLM module. I should mention that you're supposed to install drivers. in order to allow CM2 QLM detect your Qualcomm Android phone. We have a guide on that, check out our Forum.
Follow that guide to setup your drivers. Also, you should have the hardware dongle and connect it to the PC's USB port. You're going to need your drivers and the dongle to pull this off. I'm already installing the CM2 QML module Installation is done [closing installer]. At this point, you'll want to launch the Cm2 QLM module. Make sure you have your hardware dongle already connected to the PC. It usually takes a while to come up Alright! Its up right now. Head over to the Flash tab. Click on Select.
A Window should popup. In this Window navigate to the firmware folder or where you have your backup. Select the XML file then you click on Open. Now, the firmware should get detected. Click on Flash. You can always untick any of these boxes if you want. Alright, you have Wait for phone.. Power off the phone now, still with battery inside, hold both volume buttons then connect the phone to the PC via USB cord. It should get detected just like this. The phone is in EDL Mode. Flashing should commence.
I'm going to pause (recording) here because it takes a while to flash. [flashing firmware] Alright! flashing is done and I have a Done message. So that's basically how to flash a Qualcomm Android phone using Chinese Miracle II QLM module.
(10-04-2019, 10:43 PM)rehannasim ok is there a way to get programmer file for a phone who's progrrammer file can not be found any where on the internet
even manufacturers deny
i have recovery.img for the device which i want to flash, so here are my question
1) how i can do without a programmer file?
2) is there any way to do without having the programmer file?
3) Is there any way to extract it from the main device?
4) if i try these programmer file , is it safe if i use a wrong programmer file ?
5) if programmer file fails then can i reset phone to factory status?
6) can i use Miracle box to flash single partition , without having programmer file?
by programmer file i mean
prog_emmc_firehose_8909.mbn
(11-04-2019, 12:19 PM)rehannasim thanks a lot , that really helped me
what if i have the stock rom for a phone which is from same company and is based on same (8909) chip and same Os,but different model .
how much chances i have that it will have same programmer file as my phone.?
(08-06-2019, 11:21 AM)Tjaytony Please I don't know how to get the Dongle. Please refer me to where I can get one.http://s.click.aliexpress.com/e/cH0RA0LA
(21-07-2019, 04:34 PM)JIJO I have managed to figure it out...i chose XML Document and loaded firmware.
Now phone cant get detected...please help