[Please help] Update : SPF Tool Error: now- ERROR 6010 CODE DOWNLOAD FORBIDDEN
[Please help] Update : SPF Tool Error: now- ERROR 6010 CODE DOWNLOAD FORBIDDEN
(28-04-2018, 11:48 AM)marczL Hello everyone.
I have a boot loop Huawei Y6 Pro TIT-U02 after flashing a pre-root rom. I already have scatter file for my phone but when I tried flashing it with SPF tool, after the red mark it prompt an error which is BROM ERROR : S_BROM_DOWNLOAD_DA_FAIL (2004). I tried all sorts of solution I found online but unfortunately no luck.
Phone's condition: Phone is detected by pc since fastboot mode detects my device. when i connect it on pc it keeps on restarting so I guess that might be a reason that flashing is a failure.
Hopefully someone could help. thank you
(29-04-2018, 02:18 AM)marczL thank you for the reply.
By the way, before bootloop my phone was already rooted, had TWRP recovery . After a week of rooting, I can no longer install some apps, I tried factory reset but same problem arise so I decided to flash the pre-root rom through TWRP. after that it got on bootloop even when I enter into recovery mode. Only fastboot mode working.
The problem in fastboot mode is I can't make commands successful since it seems the bootloader got lock again (FRP Lock displayed) after flashing the pre-root rom (need to enable OEM Unlock in Developers Options but I can't enable it since I can't open my phone)
Most say, the only solution is through SPF Flash tool but then I encountered the Brom Error Fail 2004. thanks
(30-04-2018, 11:31 AM)hovatek(29-04-2018, 02:18 AM)marczL thank you for the reply.
By the way, before bootloop my phone was already rooted, had TWRP recovery . After a week of rooting, I can no longer install some apps, I tried factory reset but same problem arise so I decided to flash the pre-root rom through TWRP. after that it got on bootloop even when I enter into recovery mode. Only fastboot mode working.
The problem in fastboot mode is I can't make commands successful since it seems the bootloader got lock again (FRP Lock displayed) after flashing the pre-root rom (need to enable OEM Unlock in Developers Options but I can't enable it since I can't open my phone)
Most say, the only solution is through SPF Flash tool but then I encountered the Brom Error Fail 2004. thanks
From your second screenshot. All destination addresses are blank. This means you have not loaded any file for flashing
(30-04-2018, 12:24 PM)marczL I did load the scatter file for my phone and tick all except preloader then it prompted the brom error (2004)
May I ask how shall i make the flashing successful when my phone keeps on restarting when connected to pc?
fastboot flash boot boot.img
fastboot flash system system.img
(30-04-2018, 02:40 PM)X3non(30-04-2018, 12:24 PM)marczL I did load the scatter file for my phone and tick all except preloader then it prompted the brom error (2004)
May I ask how shall i make the flashing successful when my phone keeps on restarting when connected to pc?
if fastboot detects your device, then why not try flashing boot and system using fastboot then perform a factory reset after flashing
Code:fastboot flash boot boot.img
fastboot flash system system.img
(01-05-2018, 12:20 AM)marczL Already tried such fastboot commands but unfortunately there is a need to enable OEM unlock in Developer options and I can't enable it since I can't turn on my phone.