Please my tecno l9 plus is having issues with anti-inadequate mode after changing the screen.. .And for this reason I peel off the sensor component besides the camera, since then my phone has been unable to load again ..It will only show tecno when switch and still reboot severally without loading up to the homepage
If I understand you , You changed your Screen, and because of that, the light ang proximity sensors were affected either due to damage or improper installation of the touch(calibrator) which now led to anti-inadvertent mode, you then went ahead to remove the sensors. Now phone does not boot completely.
Did you pull the sensors from the board?
This post was last modified: 13-08-2018, 02:15 PM by EMMANUS.