[Samuel Banda]

Hello.

I earlier had a softbrick of by following the instructions from this site: https://www.techrrival.com/flash-recovery-adb-fastboot/ (don't follow them). My phone got stuck in bootloop.

To unbrick, I got my build number (thanks to Freshlyt & Emmanus) to compare with the two stock roms @ https://forum.hovatek.com/thread-20108.html (note that I only needed the "recovery.img" and "scatter.txt" -- full stock wasnt affected).

I flashed recovery.img from build number X559-H8015AB-N-170818V107 on my X559-H8015AB-N-180326V147 because it was the closest version available online.

After that, phone could not even boot to OSX logo (I can see Infinix Logo at the beginning).

It blinks with the error messages: "no command (blinking with a red exclamation mark)" and "Supported API: 3"

Is there anything I can do with Miracle Box to correct this?

Thank you advance :-)

[X3non]

Hello.
...
Thank you advance :-)

firmware for your build is now listed at https://forum.hovatek.com/thread-20108.html

[Samuel Banda]

firmware for your build is now listed at https://forum.hovatek.com/thread-20108.html

Much appreciated Xenon..... and.... uhhhh...yeah....that was quick. ^Whooooooooooooot ^Whooooooooooooot

[Samuel Banda]

Hello.
...
Thank you advance :-)

firmware for your build is now listed at https://forum.hovatek.com/thread-20108.html

Recovery image successfully flashed, but phone still writing the same error. What do you suggest?

[Yohanan Piadoso]

bro to get out from that stupid massage of no command you need to use miracle box to backup your phone firmware or only this file
preload.bin
secro.bin
boot.bin
recovery.bin
lk.bin
logo.bin

after done
now click on write
locate your back up file
click on format all android tab

and flash you

now that massage will be stop

please now use ur stock Rom to flash

please note if you are not using file with same build with your phone then you need to replace and rename preloader

just a easy try by me yohanan

e.g if your phone build number is different from the file

than back ur phone preloader and rename it to the file you download from net and use it to flash

but make sure you use miracle box


please note that this trick is mind with only same version of firmware
mm to mm. N to N

[sami]

Why dont you try flashing the whole firmware using SPflash tool?

[freshtyt]

Recovery image successfully flashed, but phone still writing the same error. What do you suggest?

its clear that system partition is now corrupt
just flash boot, recovery and system then try booting to homescreen, if it doesn't then perform a factory reset in recovery mode
it should boot to homescreen afterwards {but you'll loose your old files}

[Samuel Banda]

Thank you X3non, Yohanan, sami & freshtyt. Phone successfully unbricked and rooted :-) #AwesomeCombo

[Yohanan Piadoso]

you are welcome bro

[JohnVenom]

thank you