Hi, Guest! Login / Register




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Flashing assistance

#1

Hi please assist phone bricked tecno m3(soft only vibrates when powering on) trying to use sp tool only making connection and disconnection sound. Tried connecting while holding volume up/down both still not successful, tried with and without battery nothing happening, still only connection disconnection sound kindly help. I still have the stock rom.


Reply
#2
(04-23-2015, 10:28 AM)lagzdee Wrote: Hi please assist phone bricked tecno m3(soft only vibrates when powering on) trying to use sp tool only making connection and disconnection sound. Tried connecting while holding volume up/down both still not successful, tried with and without battery nothing happening, still only connection disconnection sound kindly help. I still have the stock rom.

is the phone the old or new OS type and what were you doing before it went dead?
Reply
#3
Its the old os i have the stock rom. However I have been using a ported android 5.0 for nexus phone since January. The phone just hanged tried to put it off then back on and it went dead.
Reply
#4
(This post was last modified: 04-23-2015, 04:24 PM by hovatek. )
(04-23-2015, 02:04 PM)lagzdee Wrote: Its the old os i have the stock rom. However I have been using a ported android 5.0 for nexus phone since January. The phone just hanged tried to put it off then back on and it went dead.

try a different cord and PC. also, uninstall then re-install vcom drivers using https://forum.hovatek.com/thread-440.html
also, use sp flash tool v 5
Reply
#5
(This post was last modified: 04-24-2015, 12:24 PM by lagzdee. )
I have made some progress but now when I try to flash its getting error after error mostly brom error 3149. I have tried connecting phone with volume down, volulme up, volume down + power, volume up + power, both volume buttons + power still nothing.The error in full brom error s_da_sdmmc_write failed (3149)
Reply
#6
(04-24-2015, 10:36 AM)lagzdee Wrote: I have made some progress but now when I try to flash its getting error after error mostly brom error 3149. I have tried connecting phone with volume down, volulme up, volume down + power, volume up + power, both volume buttons + power still nothing.

here's what you'll do. 
* uninstall all mediatek and vcom drivers using usb deview at the link above
* open device manager
* slot the battery into the phone but dont switch on
* connect the phone to pc
* the phone should get detected as a DA VCOM driver
* right-click this item and select update driver
* select the driver from the VCOM drivers you've downloaded
* try flashing again
Reply
#7
Still not working phone not getting detected flashing not successful despite following steps
Reply
#8
new error after steps above
.jpg   new error.JPG (Size: 27.48 KB / Downloads: 8)
Reply
#9
(04-24-2015, 02:19 PM)lagzdee Wrote: new error after steps above

use sp v 3
Reply
#10
(This post was last modified: 04-24-2015, 06:08 PM by lagzdee. )
error when I use v 3
.jpg   v3 err.JPG (Size: 32.24 KB / Downloads: 8)
Reply










Users browsing this thread:
1 Guest(s)