[Please help] Persistent problem of mismatching drivers/device. (Win10-Alcatel 1 5033D)
[Please help] Persistent problem of mismatching drivers/device. (Win10-Alcatel 1 5033D)
ERROR: STATUS_BROM_CMD_SEND_DA_FAIL (0XC0060003)
(05-03-2020, 03:32 PM)Galat Thank you for your answer.
As we might expect, I get the following error :
Code:ERROR: STATUS_BROM_CMD_SEND_DA_FAIL (0XC0060003)
This happens after attempting a readback once the MTK USB Port device disconnected/disappeared from the Device Manager, launching it just before or after the MediaTek PreLoader USB VCOM (Android) gets at its turn detected.
https://imgshare.io/image/tZZI5
(06-03-2020, 11:12 AM)Galat ...So whenever I plug the offline phone in (battery in and fully charged or at least over 80%), I can hear 3 connection and 2 disconnection successive sounds in an order of detection of that sort : MTK USB Port connected > disconnected > MediaTek PreLoader USB VCOM (Android) connected > disconnected > Linux File-CD Gadget USB Device connected.
ERROR: STATUS_BROM_CMD_FAIL (0xC0060005)
(07-03-2020, 04:46 PM)Galat ...
I also tried the same procedure by plugging the phone in the PC having got the battery off (not putting it back). I got basically the same result excluding of course the last device detection (Linux File-CD Gadget USB Device.)
(07-03-2020, 04:46 PM)Galat So far I was not holding any button while plugging the phone to PC. So now I tried to connect the phone to PC by pressing on the volume up button as it is sometimes suggested after launching the readback procedure. As a result, the MTK USB Port device got detected and I got immediately the following error :
Code:ERROR: STATUS_BROM_CMD_FAIL (0xC0060005)
It worth to note that after that, the MTK USB Port held the connection longer than the usual before disconnecting again and that the same sequential detection (connection/disconnection) as I talked about earlier starts again : MTK USB Port > MediaTek PreLoader USB VCOM (Android) > Linux File-CD Gadget USB Device.
I also tried the same procedure by plugging the phone in the PC having got the battery off (not putting it back). I got basically the same result excluding of course the last device detection (Linux File-CD Gadget USB Device.)