I tried flashing my Canon X pro
I tried flashing my Canon X pro
(03-07-2020, 01:22 PM)Rojaab My Canon X pro started going off recently so I flashed it. All was fine until it went off completely recently. It only shows the charging light and that's all.
I tried flashing it again but this time with the SP Flash tool but I keep getting the ERROR:STATUS_BROM_CMD_FAIL (0x0060005)
I used several custom DA but the same error shows.
But when I use SDaftersales V4.1811.23.11
I get a different error that says DA Connection Failed!STATUS_EXT_RAM_EXCEPTION[1/1][100%]
please, I have used up all the custom DA i can find.
I have tried disconnecting and reconnecting the batter too.
Please help me.
BTW:I have also tried downloading the stick Rom another site. All the same.
Help please, I really need this phone.
(05-07-2020, 11:54 PM)Rojaab I foolishly failed to get the build number before giving it to my friend to help flash.
After the first flash, it was successful. Like I said it worked for about 2 months then started the same problem again. Only that this time, it goes off does not come on. Only showing the charging light.
May I also add that after it went off totally, it now connects and disconnects repeatedly.
I followed the suggestion I found on another thread to remove the battery and reconnect.
I did and also use another version of Sdwsale software. Now it doesn't disconnect again.
When I try to flash, it requests for auth file.
I got the auth sv5.auth file and now the errors I get is what I post above.
Thanks for responding to my plea.
Bless you sir.
(08-07-2020, 06:34 PM)Rojaab Thanks, I tried it however it says chip ID mismatch error.
Thanks
Then I realised the link firmwares are for CA8 (Camon X Pro).
But I am trying to Flash CF8 (Camon 11 pro)