[Please help] Failed Format Userdata on SP Flash Tool Via Console
[Please help] Failed Format Userdata on SP Flash Tool Via Console
(09-09-2021, 02:41 PM)X3non(09-09-2021, 05:20 AM)linssang ...
begin address and length already same with scatter.
but no success report
device not format after that
are you using the custom DA for this model or mtk bypass?
whats the error message and why not use the gui?
(14-09-2021, 02:51 PM)linssang i using mtk bypass
no error message
just disconnected
i think its easier to run on console
no need to input address
(15-09-2021, 11:11 AM)X3non(14-09-2021, 02:51 PM)linssang i using mtk bypass
no error message
just disconnected
i think its easier to run on console
no need to input address
you can try UART connection type and specify the port too, see if that helps
BTW so long as you're doing a manual format, you still to input address even if you're using console mode
(08-10-2021, 07:17 AM)linssang already use this but no sign of complete sir
if i using console mode, just need one time for doing manual format.
because i need doing it multiple time.
(08-10-2021, 08:30 AM)hovatek(08-10-2021, 07:17 AM)linssang already use this but no sign of complete sir
if i using console mode, just need one time for doing manual format.
because i need doing it multiple time.
Try in GUI . Lets be sure its not a console thing
(08-10-2021, 08:31 AM)linssang GUI is success
but not console sir