Hi, Guest! Login / Register




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

[Tutorial] flash error issues

#1

Pls I tried that but am getting BROM ERROR : S_FT_ENABLE_DRAM_FAL(4032) N THE PHONE DON'T SWITCH ON AGAIN

....also I as I was following the video to install the drivers after installation only media ten DA USB VCOM port installed n ur video I saw both DA USB vcom port(com46) n Media Tek Preloaded USB VCOM PORT (com19) installed... Will this cause an issue if yes how can I rectify it...


Reply
#2
(08-04-2015, 07:24 PM)mike101 Wrote: Pls I tried that but am getting BROM ERROR : S_FT_ENABLE_DRAM_FAL(4032) N THE PHONE DON'T SWITCH ON AGAIN

....also I as I was following the video to install the drivers after installation only media ten DA USB VCOM port installed n ur video I saw both DA USB vcom port(com46) n Media Tek Preloaded USB VCOM PORT (com19) installed... Will this cause an issue if yes how can I rectify it...

if you have an existing thread then kindly stick to it to avoid a mixup
Reply
#3
OK but plss the problem persist
Reply










Users browsing this thread:
1 Guest(s)