[Tutorial] How to fix MTK or SPD bricked after interrupting flash or backup
[Tutorial] How to fix MTK or SPD bricked after interrupting flash or backup
(31-03-2020, 07:53 AM)Akwo Tom I have an Infinix Hot7 MT6580. I flashed with the right firmware, and the process completed. But right now the device fails to power on.
When I connect to the PC over USB, it keeps disconnecting and reconnecting. When I try to flash it again I get "S_FT_ENABLE_DRAM failed, please make the firmware matches the target." And this option keeps repeating whenever I try to flash any other firmware (I've tried all the 3 Infinix Hot7 firmwares)
Please what can I do?
(07-04-2020, 03:30 AM)XiaoKang Zhao Hello! My Nokia X5 (5.1 plus) phone with MT6771 got brciked after a forced shutdown.
When I try to flash it with the flash tool, it just stucked with a red "da download 100%"bar. The correct driver has been installed on my PC.
Now it seems totally dead. As it has an inbuilt battery, do I need to keep on holding the power button while charging until it comes up?(for Tip 4) Or there are any better solutions? thx
(07-04-2020, 03:30 AM)XiaoKang Zhao Hello! My Nokia X5 (5.1 plus) phone with MT6771 got brciked after a forced shutdown.
When I try to flash it with the flash tool, it just stucked with a red "da download 100%"bar. The correct driver has been installed on my PC.
Now it seems totally dead. As it has an inbuilt battery, do I need to keep on holding the power button while charging until it comes up?(for Tip 4) Or there are any better solutions? thx
(12-07-2020, 03:08 AM)fabysmooth I bricked my mtk device after trying to flash factory rom and the battery died. I charged it for a couple days now i can see the offline charging animation but no indication if it is charging or not. Should i just continue to charge until it indicates that it is charging?? my device is a blu studio xl2 mt6737 with a built- in battery
(12-07-2020, 07:41 PM)innageethe battery ran down during flashing(12-07-2020, 03:08 AM)fabysmooth I bricked my mtk device after trying to flash factory rom and the battery died. I charged it for a couple days now i can see the offline charging animation but no indication if it is charging or not. Should i just continue to charge until it indicates that it is charging?? my device is a blu studio xl2 mt6737 with a built- in battery
was flashing successful before the battery ran down or it ran down during flashing and interrupted?